Compact single-phase type 2 (or 3) surge protector - 120 V - Monobloc
DS98L-120
Part Number: 3519012
- Cost effective single-phase surge protector
- Safety disconnection in-line
- Double connection in series
- Common/Differential mode
Datasheet
DS98L AC surge protector is used for the 'secondary' protection of the single-phase networks against the surge voltages creating by lightning.
DS98 is equipped with in-line safety disconnectin and double output connection.
The disconnection will be indicate by the turn on of the red led in the front.
Very compact, the DS98L surge protector must be installed close by the equipment to protect, downstream a 'primary' surge protector.
DS98L provides both a common and differential mode protection.
Select another reference:
| SPD type | 2 (or 3) | |
| Network | 120 V single-phase | |
| AC system | TN | |
| Nominal line voltage | Un | 120 Vac |
| Max. AC operating voltage | Uc | 150 Vac |
| Max. load current | IL | 16 A |
| Temporary Over Voltage (TOV) Charasteristics - 5 sec. | UT | 180 Vac withstand |
| Temporary Over Voltage (TOV) Charasteristics - 120 mn | UT | 230 Vac disconnection |
| Operating current | Ic | None |
| Follow current | If | None |
| Nominal discharge current | In | 5 kA |
| Max. discharge current | Imax | 10 kA |
| Total Maximum discharge current | Imax Total | 20 kA |
| Withstand on Combination waveform IEC 61643-11 | Uoc | 10 kV |
| Withstand on overvoltages IEEE C62.41.1 | 10 kV | |
| Connection mode(s) | L/N/PE | |
| Protection mode(s) | Common/Differential mode | |
| Protection level L/N | Up L/N | 0.7 kV |
| Protection level N/PE | Up N/PE | 0.7 kV |
| Admissible short-circuit current | Isccr | 10 000 A |
| SPD configuration | Single phase | |
| Connection to Network | by screw terminals : 2.5 mm² max. | |
| Format | Plug-in modular box | |
| Mounting | Symmetrical rail 35 mm (DIN 60715) | |
| Housing material | Thermoplastic UL94 V-0 | |
| Operating temperature | Tu | -40/+85°C |
| Protection rating | IP20 | |
| Failsafe mode | AC network cutt-off | |
| Disconnection indicator | Red light on | |
| Remote signaling of disconnection | No | |
| Dimensions | See diagram |
| Standards compliance | IEC 61643-11 / EN 61643-11 / UL1449 4ed. | |
| Certification | EAC |
| Thermal disconnector | Internal | |
| Installation ground fault breaker | Type 'S' or delayed | |
| Fuses | Fuses type gG - 20A |
