Ultra Compact Type 2+3 hard wired surge protector
MLPX1VG-230L-W
MLPX1VG-230L-W
Part Number: 711294
  • Ultra compact Type 2+3 hard wired surge protectors
  • Wall mounting and hard wired connection
  • VG Technology
  • No aging
  • Bracket breakable
  • Protection rating : IP67
  • Disconnection signaling by indicator
  • AC disconnection in case of end of life
  • EN 61643-11, IEC 61643-11 and UL1449 4ed. compliance
Installation Sheet


Select another reference:

SPD type
following IEC test
2+3
Network
230-277 V single-phase
AC system
TT/TN
Nominal line voltage
230 V
Max. AC operating voltage L-N 320 Vac
Max. load current
10 A
Temporary Over Voltage (TOV) Charasteristics - 5 sec.
without disconnection
335 Vac withstand
Temporary Over Voltage (TOV) Charasteristics - 120 mn
without disconnection or with safety disconnection
440 Vac disconnection
Temporary Over Voltage N/PE (TOV HT)
without disconnection or with safety disconnection
1200 V/300A/200 ms disconnection
Residual Current
Leakage current to Ground
None
Nominal discharge current
15 x 8/20 µs impulses
5 kA
Max. discharge current
max. withstand @ 8/20 µs by pole
10 kA
Total lightning current
max. total withstand @ 10/350µs
20 kA
Withstand on Combinaison waveform IEC 61643-11
Class III test: 1.2/50µs - 8/20µs
10 kV
Withstand on overvoltages IEEE C62.41.1 10 kV / 10 kA
Admissible short-circuit current 10000 A
Protection mode(s)
Common/Differential mode
Protection level L/N
@ In (8/20µs)
1.5 kV
Protection level L/PE
@ In (8/20µs)
1.5 kV
Protection level CM/DM
@ In (8/20µs)
1.5 kV / 1.5 kV
 
Technology MOV+GDT
Connection to Network by wires : 1.5 mm² (L/N) and 2.5 mm² (PE)
Mounting Wall or plate
Housing material Thermoplastic UL94-V0
Operating temperature -40/+85°C
Protection rating IP67
Failsafe behavior Disconnection and AC line cut-off
Disconnection indicator Led green OFF and AC network cut-off
Voltage/operating indicator Green Led ON
Remote signaling of disconnection no
Dimensions
See diagram
Standards compliance IEC 61643-11 / EN 61643-11 / UL1449 4ed.
Installation ground fault breaker Type 'S' or delayed
Thermal disconnector Internal