1-pair monobloc Data surge protector

DLUH-48D3

Part Number: 640704

For DIN rail mounting
Monobloc housing
1-pair
Max. line current 2.4 A
Un: 48 V
Transmission an protection of shield wire
IEC 61643-21 compliance
UL497A

Datasheet
Tender specifications

DLUH surge protectors are designed to protect, against surge voltages due to lightning, terminals equipment connected to industrial buses, telecom lines or datalines. These surge protectors must be installed on symmetrical DIN rail and are available for most of the transmission lines: line voltage from 6 to 170V, bitrate up to 10 Mbit/s. These products are 1-pair surge protectors and are made with DIN rail monobloc enclosure

Select another reference:

Electrical Properties Mechanical Properties Norms Schemas

Network		48 V line, ISDN-T0, Profibus-PA
Nominal line voltage	Un	48 V
Max. DC operating voltage	Uc	53 Vdc
Max. frequency	f max.	> 3 MHz
Insertion loss		< 1 dB
Max. load current	IL	2.4 A
Max. discharge current	Imax	20 kA
Line inductance		No
Protection mode(s)		Common/Differential mode
Protection level	Up	70 V
Max. capacitance	C	< 50 pF
Impulse current	Iimp	5 kA
Nominal discharge current	In	5 kA
Line resistance		0 Ohm

Technology		GDT+Clamping diode
SPD configuration		1-pair+shielded
Connection to Network		By screw terminal: cross section 0.4-1.5mm²
Format		DIN box
Mounting		Symmetrical rail 35 mm (EN 60715)
Housing material		Thermoplastic UL94 V-0
Operating temperature	Tu	-40/+85°C
Protection rating		IP20
Outdoor application		No
Failsafe mode		Short-circuit - transmision cut-off - fault mode 2
Disconnection indicator		Transmission interrupt
Remote signaling of disconnection		No
Max. number of pairs		1
Dimensions		See diagram

Standards compliance		IEC 61643-21 / EN 61643-21 / UL497A
Certification		UL listed