Type 1+2 AC surge protector 3-phase

DAC1-13S-30-150
Part Number: 821710123
DAC1-13S-30-150
  • Type 1 + 2 AC surge protector
  • In : 20 kA
  • Iimp : 12.5 kA
  • Pluggable module for each phase
  • Remote signaling
  • EN 61643-11, IEC 61643-11 certified
  • UL1449 ed.5 compliance
Contact Us
The DAC1-13 is an extreme duty Type 1+2 pluggable SPD designed to protect AC powerline at the main switchboard of an installation equipped with lightning rod. The technology ‘Multi-varistor” allows a very high discharge current capability in small dimensions and the best possible behavior to the AC network (no follow current). In the light of their high discharge capability, the DAC1-13 surge protectors are especially compact and are available in multipolar versions to protect single or 3-phase AC networks.
SPD type 1+2
Network 120/208 V 3-phase
AC system TNC
Max. AC operating voltage Uc 150 Vac
Temporary Over Voltage (TOV) Charasteristics - 5 sec. UT 180 Vac withstand
Temporary Over Voltage (TOV) Charasteristics - 120 mn UT 230 Vac disconnection
Residual Current Ipe < 1 mA
Follow current If None
Nominal discharge current In 20 kA
Max. discharge current Imax 50 kA
Total Maximum discharge current Imax Total 150 kA
Impulse current by pole Iimp 12.5 kA
Total lightning current Itotal 37.5 kA
Specific energy by pole W/R 40 kJ/ohm
Protection mode(s) L/PE
Protection level L/PE Up L/PE 1.2 kV
Residual voltage L/PE at 5 kA Up-5kA 0.6 kV
Admissible short-circuit current Isccr 50 000 A
Network type AC
Technology MOV
SPD configuration 3-phase
Connection to Network By screw terminals: 2.5-25mm² (35mm² rigid)
Format Plug-in modular box
Plugable Yes
Mounting Symmetrical rail 35 mm (EN 60715)
Housing material Thermoplastic UL94 V-0
Operating temperature Tu -40/+85°C
Protection rating IP20
Failsafe mode Disconnection from AC network
Disconnection indicator 1 mechanical indicator by pole - Red/Green
Spare module(s) MDAC1-13-150
Remote signaling of disconnection Output on changeover contact
Wiring for remote signaling max. 1.5 mm² single-/multi-wire
Max. Voltage/Current for remote signaling 250 V / 0.5 A (AC) / 30 V / 3 A (DC)
Dimensions See diagram - 3 TE (EN43880)
Weight 0.413 kg
Standards compliance IEC 61643-11 / EN 61643-11 / UL1449 ed.5
Certification KEMA / EAC
Thermal disconnector Internal
Installation ground fault breaker Type 'S' or delayed
Fuses Fuse assembly: SFD1-13S-30 / or 125 A min. - 315 A max. - Fuses Type gG