Compact 1-phase Type 2 (or 3) surge protector - 120 V -Pluggable
DAC40CS-20-150
DAC40CS-20-150
Part Number: 821510121
  • Compact single-phase type 2 (or 3) surge protector
  • In : 20 kA
  • Imax : 40 kA
  • Commun/Differential mode
  • Pluggable module
  • Remote signaling
  • EN 61643-11, IEC 61643-11 and UL1449 ed.4 compliance
Installation Sheet
Contact Us
The pluggable compact surge protectors Type 2 or Type 3 DACC, are designed to protect electrical installation at the main switchboard or at secondary panels.. Their compact format allow to install it in limited space. This SPD is based on high energy varistor equipped with thermal disconnector and failure indicator, to comply with standards. guaranteeing a maximum protection efficiency, an high impulse current capability and a improved reliability. DACC surge protectors are available in 2 impulse current versions (DAC15C et DAC40C), in multipolar configuration and in several operating voltages to protect all kind of single or 3-phase AC networks.
SPD type 2
Network 120 V single-phase
AC system TN
Max. AC operating voltage L-N Uc 150 Vac
Temporary Over Voltage (TOV) Charasteristics - 5 sec. UT 180 Vac withstand
Temporary Over Voltage (TOV) Charasteristics - 120 mn UT 230 Vac disconnection
Residual Current Ipe < 1 mA
Follow current If None
Nominal discharge current In 20 kA
Max. discharge current Imax 40 kA
Protection mode(s) L/PE and N/PE
Protection level N/PE Up N/PE 0.9 kV
Protection level L/PE Up L/PE 0.9 kV
Admissible short-circuit current Isccr 10 000 A
Technology MOV
SPD configuration Single phase
Connection to Network by screw terminals: L/N = 1.5-10mm² (16mm² rigid) or PE = 2.5-25mm² (35 mm² rigid)
Format Plug-in modular box
Mounting Symmetrical rail 35 mm (EN60715)
Housing material Thermoplastic UL94-V0
Operating temperature -40/+85°C
Protection rating IP20
Disconnection indicator 1 mechanical indicator - Red/Green
Spare module(s) MDAC40C-20-150
Remote signaling of disconnection Output on changeover contact
Wiring for remote signaling 1.5 mm² max.
Maw. Voltage/Current for remote signaling 250 V / 0.5 A (AC) / 30 V / 3 A (DC)
Dimensions See diagram - 1TE (EN43880)
Standards compliance IEC 61643-11 / EN 61643-11 / UL1449 4ed.
Certification IEC 61463-11 / EN 61643-11