Type 1+2 AC surge protector - 3-phase+N
Part Number: 5042301
DS504E-230/G
- Type 1 + 2 multipolar AC surge protector
- Iimp total : 100 kA (10/350µs impulse)
- Imax : 200 kA (8/20µs impulse)
- Internal disconnections, status indicator and remote signaling
- Conforme NF EN 61643-11, IEC 61643-11, UL1449 ed.5
The DS500E range of surge protectors are Type 1 + 2, very high power, they are intended to be installed at the entry of the Low Voltage installation.
They are used to protect single-phase, three-phase or three-phase + Neutral networks in common mode or in common and differential mode.
The 'Multi-Varistor' technology used allows the best possible behavior for the LV network (no follow-on current).
The DS500E range is installed on a DIN Rail and has a double connection for the active conductor, which allows an optimized connection to the network.
Certificates
Datasheet
|
SPD type
|
IEC | 1+2 |
|
Network
|
230/400 V 3-phase+N |
|
|
AC system
|
TT-TNS |
|
|
Nominal line voltage
|
Un | 230 Vac |
|
Max. AC operating voltage
|
Uc | 255 Vac |
|
Max. load current
if series connection
|
IL | 100 A |
|
Temporary Over Voltage (TOV) Characteristics - 5 sec.
Without disconnection
|
UT | 335 Vac withstand |
|
Temporary Over Voltage (TOV) Characteristics - 120 mn
Without disconnection or with safety disconnection
|
UT | 440 Vac disconnection |
|
Temporary Over Voltage N/PE (TOV HT)
Without disconnection or with safety disconnection
|
UT | 1200 V/300A/200 ms withstand |
|
Operating current
Continious current at Uc
|
Ic | None |
|
Follow current
|
If | None |
|
Nominal discharge current
15 x 8/20 µs impulses
|
In | 50 kA |
|
Max. discharge current
max. withstand @ 8/20 µs by pole
|
Imax | 200 kA |
|
Impulse current by pole
max. withstand 10/350µs by pole
|
Iimp | 50 kA |
|
Total lightning current
max. total withstand @ 10/350µs
|
Itotal | 100 kA |
|
Specific energy by pole
max. withstand 10/350 µs
|
W/R | 625 kJ/ohm |
|
Connection mode(s)
|
L/N and N/PE |
|
|
Protection mode(s)
|
Common/Differential mode |
|
|
Protection level L/N
@ In (8/20µs)
|
Up L/N | 1.8 kV |
|
Protection level N/PE
@ In (8/20µs)
|
Up N/PE | 1.5 kV |
|
Admissible short-circuit current
|
Isccr | 50 000 A |
|
Technology
|
MOV |
|
|
SPD configuration
|
3-phase+Neutral |
|
|
Connection to Network
|
By screw terminals: 6-35mm² / by bus |
|
|
Format
|
1-pole modular box assembled |
|
|
Mounting
|
Symmetrical rail 35 mm (EN 60715) |
|
|
Housing material
|
Thermoplastic UL94 V-0 |
|
|
Operating temperature
|
Tu | -40/+85°C |
|
Protection rating
|
IP20 |
|
|
Failsafe mode
|
Disconnection from AC network |
|
|
Disconnection indicator
|
1 mechanical indicator by pole |
|
|
Remote signaling of disconnection
|
Output on changeover contact |
|
|
Dimensions
|
See diagram |
|
Standards compliance
|
IEC 61643-11 / EN 61643-11 / UL1449 ed.5 |
|
|
Certification
|
|
Thermal disconnector
|
Internal |
|
|
Installation ground fault breaker
|
Type 'S' or delayed |
|
|
Back-up protection device
|
Fuses Type gG - 500 A |
